My Projects

While waiting on the rev two dual board and the single ESP32 board i started work on its first shield a 3D Printer shield based on my rumba already fitted into my D-Bot Printer got a few bits hanging off the side and still got to another fan controller a Fet to drive my solid state relay, please note this board will only have small Fet for heated bed so it will need an external solid state relay as my 24V silicone heated pad draws 45 amps so i decided safer to use a 60 amp solid state relay was much cheaper than the cost of 2oz copper. Should have ready to send to Elecrow by the time the other boards arrive tomorrow. Update this as it progresses still deciding which firmware to port.

 

Add comment


Security code
Refresh